During the production and use of servo hydraulic presses, in addition to paying attention to operating standards and regular repairs and maintenance, we must also find ways to improve the efficiency of hydraulic presses. Following, we will introduce a few points about how to improve the efficiency of hydraulic press:
                                
1. The operator of a servo hydraulic press must understand the principles of the hydraulic system, understand the functions of the main hydraulic components of the equipment, and master the operating procedures of the system. Before starting the equipment, you should check whether all moving mechanisms and solenoid valves have entered the initial state, and check the oil level in the fuel tank. If an abnormality or lack of oil is found, you should stop starting the hydraulic pump motor and find a repairman for repair. Operators should frequently check the working status of the hydraulic system, observe the operating pressure and speed, check the size of the workpiece and the wear status of the props, to ensure that the hydraulic system operates smoothly and reliably.
2. In winter, when the oil temperature of the fuel tank does not reach 25°C, each execution mechanism cannot start working in sequence, but can only start the hydraulic pump motor to make the hydraulic pump work empty. During summer operations, when the oil temperature in the tank is higher than 60°C, pay attention to the operating conditions of the hydraulic system and notify maintenance personnel to deal with it. The operator cannot damage the interlocking device of the electrical system, cannot push the electronic control valve by hand, and cannot damage or arbitrarily move the position of each operating gear.
3. For hydraulic press machine that has been shut down for more than 4 hours, before starting work, the hydraulic pump motor should be started for 5-10 minutes before working under pressure. When a malfunction occurs in the hydraulic system, the operator cannot move without permission and should report to the maintenance department immediately. Hydraulic press machine should be cleaned frequently to prevent dust, cutting fluid, cutting chips, cotton yarn and other debris from entering the fuel tank.